5 x Fibre Optic connectors

Each lens connects to the LED chips to provide a way of routing fibre optic cable to another location. Fibre optic cable approx 30cm length per strand, 1mm thickness. Note these are included in the starter kits.

5 x Short Cables

Each cable is approximately 6cm long and connects to either our strips or interlocking LEDs. Cables can be daisy chained together to increase the length if required. Note these are included in the starter kits.

5 x Long Cables

Each cable is approximately 21cm long and connects to either our strips or interlocking LEDs. Cables can be daisy chained together to increase the length if required. Note these are included in the starter kits.

Fibre Optic Cable x 1m

1 meter of Fibre Optic cable. Available in two widths, 0.5mm or 1mm.

Controller Power Pack

5V DC USB power supply (correct country version will be supplied) with USB extension lead and USB Controller / LED connection lead. Note these are included in the Starter Kits.

Wireless Controller

(Pro Controller Only). This wireless presentation controller includes a USB dongle which plugs directly in to the Pro Controller. You can then recall up to 6 scenes using the 3 available buttons, wirelessly. (Single press or press & hold for each button). Also includes a low power laser pointer.

Expansion Board

(Pro Controller Only). This board allows you to control up to 6 x 5V DC devices, eg standard LEDs (including dimming), Laser Modules etc, as if they were addressable LEDs on the data chain. The board uses the same protocol as WS2811 / SK6815 addressable LEDs. 2 On board RGB LEDs are also incuded, which can be used with the fibre optic connectors if required. Multiple boards can be daisy chained together, or inserted anywhere on the addressable LED data line. The board takes up either 4 x RGB LED slots, or 3 x RGBW slots - it is compatible with either type of LED system. 500mA max per output. Compatible with the InnerLight Pro controller, or can be used in any standard neopixel / WS281x project. Note soldering is required (solderless version available on request)